Cosmostreamer for DJI Pocket 3

Hardware

Cosmostreamer for DJI Pocket 3 can work on these boards:

Raspberry Pi 4B

Any RAM size. 1Gb, 2Gb, 4Gb, 8Gb.

• Two micro-HDMI outs
• Analog video out (CVBS, TV-out) in 3.5 mini-jack
• DSI display may be used. If DSI display connected - only HDMI-0 may be used.
• Wi-Fi 2.4/5 GHz
• Ethernet 10/100/1000 Mbit/s
• 2 USB 2.0 ports + 2 USB 3.0 ports
• 1 USB-C port (can be used as power input)

Raspberry Pi 3B/3B+

• HDMI port
• Analog video out (CVBS, TV-out) in 3.5 mini-jack
• DSI display may be used. If DSI display connected - HDMI can't be used.
• Wi-Fi 2.4 GHz (RPI 3B) or 2.4/5 GHz (RPI 3B+)
• Ethernet 10/100/1000 Mbit/s
• 4 USB 2.0 ports
• 1 micro-USB port for power in

Installing the Cosmostreamer firmware

1. Get a blank microSD card of 8GB or larger. Insert the microSD card into the card reader
2. Download ZIP-archive with firmware content
3. Extract .img file from downloaded ZIP archive
4. Use Win32DiskImager on Windows or Balena Etcher on Mac and write .img file on microSD card
5. Insert the microSD card into the Raspberry Pi
6. If you have a monitor or a TV with HDMI input - plug it to the Raspberry Pi HDMI port (if Rpi 4B is used - HDMI-0 port, nearest to USB-C port)
7. Plug a standard USB power supply or powerbank to the Raspberry Pi (go to chapter Power for Raspberry Pi). Raspberry Pi must start booting. A couple of reboots may be during the first boot
   

Power for Raspberry Pi

Power with standard Micro-USB or USB-C port

USB-C port on Raspberry Pi 4, micro-USB port on Raspberry Pi 3 B/B+

Settings and controls

Browser

Video in browser may not work properly, need to switch photo/video mode

Also you could open Cosmostreamer web admin page in browser
http://192.168.50.1
http://my.cosmostreamer.com
http://cosmostreamer.local

Windows application

Download, install and run CosmoViewerNG application.

Mac application

Both licenses, for "Video in browser may not work properly, need to switch photo/video mode

Download, install and run CosmoViewerNG application.