Cosmostreamer for DJI Goggles2/Integra

Installing the Cosmostreamer firmware

1. Get a blank microSD card of 8GB or larger. Insert the microSD card into the card reader
2. Download ZIP-archive with firmware content
3. Extract .img file from downloaded ZIP archive
4. Use Win32DiskImager on Windows or Balena Etcher on Mac and write .img file on microSD card
5. Insert the microSD card into the Raspberry Pi
6. If you have a monitor or a TV with HDMI input - plug it to the Raspberry Pi 4B HDMI0- port (nearest to USB-C port)
7. Plug a standard USB power supply or powerbank to the Raspberry Pi GPIO pins (see chapter "Raspberry Pi power"). Raspberry Pi must start booting. A couple of reboots may be during the first boot process.

Power for Raspberry Pi

For using with DJI Goggles2/Integra Raspberry Pi 4 must be powered ONLY from GPIO or from PoE or via USB-C port with custom cable.

Power with GPIO (pins)

Use any USB cable, need to cut it and connect to the RPI only 2 wires - Red (5V) and Black (Gnd). Then you can use it with any standard USB power supply or powerbank.

Power with USB-C port

USB-C port on Raspberry Pi 4 is busy by Goggles2/Integra connection, so need to made a custom USB cable with additional part for power.

Power with PoE

Only for Raspberry Pi 4B and 3B+. Need to use PoE Hat.

Network connection

Ethernet

Only for Raspberry Pi versions with Ethernet port. Connect Ethernet cable to the Raspberry Pi Ethernet port at one side and home router or PC/Mac Ethernet port on another side

Wi-Fi

Connect your PC/Mac or smartphone to Wi-Fi network cosmostreamer, password 1234512345

Settings and controls

Browser

Also you could open Cosmostreamer web admin page in browser
http://192.168.50.1
http://my.cosmostreamer.com
http://cosmostreamer.local

Windows application

Download, install and run CosmoViewerNG application.

Mac application

Download, install and run CosmoViewerNG application.